Unlike simple protective covers--This billet water pump housing is a complete replacement for the weak cast stock piece. It was designed to protect the vulnerable left side of your Ducati engine.
Proven to increases the flow and efficiency of your cooling system, this pump also acts as a heat sink, netting up to 10% cooler running temperatures compared to the stock piece. Made from T6 billet aluminum, it is the toughest pump housing you can buy.
The kits come complete with polished bolts, stainless steel hose fitting and easy to install instructions. Ease your mind and help protect your investment from tip-over mishaps or racetrack inevitability.
02-0202/04 Fits: Testaretta motors-998, 998R, 996R, 749-999, 1098/1198, SF and 03+ ST, S4R.
02-0201/03 Fits: Desmoquattro motors Post-1998 748, 996, Pre-2003 ST's, S4 Monsters (except S4R)
Fitment notes:
Here are some guide lines you can use to figure out what water pump (of the three Ducati made) is on the bike.
1) If the Pump cover only has 4 bolts and a drain, its too old and Speedymoto does not have an application.(usually pre 98, but be careful of the SPS,RS,R bikes)
2) If the pump has 5 bolts and has a fiber gasket, use SpeedyMoto part # 02-0201 (usually 98-01 but will also work on the 02' 916 powered ST-4 and S4 monster)
3) If the pump has 5 bolts (one of the bolts has a copper washer under it) and uses liquid gasket material to seal the pump, use Speedymoto part # 02-0202 (usually 02 till current,but be careful of the left over 916 motors used in the S4 monster and the ST-4)
Ducati has a bunch of odd balls out there like the various SPS/RS/R/S bikes, use these guide lines to help fine the right pump and if that doesn't work please feel free to give us a quick call.
